Enterasys Networks Network Card - Manual (Page 56)

44
RiverMaster Administrator’s Guide
Tunnel Protocols Chapter 3
Configuring an ANG-3000/7000
1 Open the Configuration pullout.
2 In the list of Aurorean devices, expand the tree list under Servers
(click the + symbol).
3 Expand the tree list under the name of your ANG.
4 Click on Tunnel Protocols to display PPTP and IPSec protocol tab
pages.
The Tunnel Protocols window appears as shown in Figure 23.
Figure 23 Tunnel Protocol General Settings
5 If you want to prevent remote clients from using one of the tunnel
protocols, select the protocol and click Remove.
By default, PPTP and IPSec are both enabled for client use. You
normally control protocol usage on a per group basis by selecting the
protocol when you assign group policies (refer to Chapter 6 for
instructions). If you want to globally disable a protocol, you can
remove it from this list. If you have removed a protocol and want to
reinstall it, click Add once and when the highlighted tunnel protocol
pops up, click Add again. You are not required to click Apply.
Click here to
access the
Gateway
configuration
windows
Click here to
open the
Configuration
pullout