Enterasys Networks Network Card - Manual (Page 125)

RiverMaster Administrator’s Guide
113
Chapter 5 Adding Corporate ISPs
Controlling Remote User Dialing & Access
23 Choose the dial-up protocols supported by the ISP from the Frame
Protocols menu.
Nearly all ISPs and dial-up Remote Access Service (RAS) servers
support the default Point-to-Point Protocol (PPP). If the dial-up
server at the ISP supports other protocols, such as Serial Line
Interface Protocol (SLIP), you may choose another protocol from the
menu.
24 Select the Network Protocols to use over the dial-up connection as
follows:
– To enable TCP/IP protocol over the dial-up connection, place a
check next to TCP/IP. This protocol is required for Internet
access.
– To enable Microsoft’s NetBEUI protocol over the dial-up
connection, please a check next to NetBEUI. NetBEUI provides
fast network browsing in small networks that are primarily
Microsoft-based.
– To enable IPX and SPX protocols over the dial-up connection,
place a check next to IPX/SPX. These protocols are normally
required for access to Novell NetWare servers.
NOTE
NetBEUI is not a routable protocol. You should select at least one other
protocol to allow packets to be routed through the Internet or corporate
network.
25 Do one of the following:
– Click Update to save the new ISP information.
– Click Cancel to clear the ISP information without saving your
changes.