Enterasys Networks Network Card - Manual (Page 66)

54
RiverMaster Administrator’s Guide
Routing Chapter 3
Configuring an ANG-3000/7000
8 Do one of the following:
– If you are setting up your Aurorean Virtual Network for the first
time, continue with the next subsection to configure additional
ANG network settings.
– If no additional ANG network configuration is required and you
want to put the new network settings into effect, reset the ANG.
Routing
Configuring the routing behavior of the ANG consists of two general steps:
H Setting parameters for the two routing protocols supported, RIP and
OSPF.
H Selecting routing protocols for each ANG Ethernet interface.
Figure 30 Aurorean Network Gateway Routing Configuration
Click here to
access the
Gateway
configuration
windows
Click here to
open the
Configuration
pullout