Enterasys Networks Network Card - Manual (Page 249)

RiverMaster Administrator’s Guide
237
Appendix B Configuring Routing Interfaces
ANG-3000/7000 Preconfiguration Stored on a Floppy Disk
Figure 135 Routing Interfaces Configuration - RIP
2 In the RIP Authentication fields, choose the algorithm (simple or
none) used by routers on your network.
If the routers on your network do not require passwords to accept
RIP updates, set the algorithm to None and skip to Step 6.
NOTE
RIP update authentication is only supported by RIP Version 2. If the
routers on your network only support RIP Version 1, you cannot enter
values in the RIP Authentication fields.
3 Type the RIP authentication password used by routers on your
network in the Password field.
RIP authentication passwords are used by routers to determine if
they should accept updated routing information sent from another
router. If your routers do not authenticate updates, leave this field
blank and skip to Step 6.
4 Type the same password in the Re-Type Password field exactly as
you entered it in Step 3.
These values are
used to authenticate
RIP updates from
routers on the network