Enterasys Networks Network Card - Manual (Page 251)

RiverMaster Administrator’s Guide
239
Appendix B Configuring Routing Interfaces
ANG-3000/7000 Preconfiguration Stored on a Floppy Disk
Figure 136 Routing Interfaces Configuration - OSPF
2 Type the same password in the Re-Type Authentication Password
field exactly as you entered it in Step 2.
3 Do one of the following:
– Click Apply to save the OSPF parameter changes, click Cancel to
close the window, and click Next to continue configuration.
– Click Cancel to close the window without saving your changes.
– Click Reset to the return the interface’s protocol properties to
their default settings.
Creating Static Routes
The trusted interface should be connected to a protected network segment -
one behind a firewall or router that offers protection against unauthorized
access. If you prefer to limit the routes the ANG learns or you do not use
routing protocols on your network, set up a trusted Static Route.
CAUTION
The ANG requires that a static route be established to the Gateway
router from the External interface to enable traffic to reach the
Internet. The external interface may reside outside a firewall and
offers unfiltered Internet access.