Enterasys Networks Network Card - Manual (Page 64)

52
RiverMaster Administrator’s Guide
Virtual Subnetting Chapter 3
Configuring an ANG-3000/7000
7 Enter the starting address of the subnet in the Address fields.
You can use actual IP addresses from your network or non-routable
IP address ranges (such as 192.168.x.x for a Class C network).
8 Enter a subnet mask to define the subnet range in the Mask field.
9 Do one of the following:
– Click Add to add the new virtual subnet.
– Click Cancel to close the window without saving your changes.
10 Repeat Step 6 through Step 9 for each virtual subnet you require.
11 Click Apply to save your changes.
To return the parameters to their original settings without saving
your changes, click Reset.
12 Do one of the following:
– If you are setting up your Aurorean Virtual Network for the first
time, continue with the next subsection to configure additional
ANG network settings.
– If you are finished with the ANG network configuration and you
want to put the new network settings into effect, no additional
work is required.
IPX Virtual Networks
To set up a single IPX network number to allocate to remote users, perform
the following steps:
1 Open the Configuration pullout.
2 In the list of Aurorean devices, expand the tree list under Servers
(click the + symbol).
3 Expand the tree list under the name of your ANG.
4 Click on Subnetting to display IP and IPX subnet tab pages.
5 Click the IP Virtual Networks tab if it is not already displayed.
A sample IPX virtual networks window is shown in Figure 29.