Enterasys Networks Network Card - Manual (Page 243)

RiverMaster Administrator’s Guide
231
Appendix B Configuring Routing Protocols
ANG-3000/7000 Preconfiguration Stored on a Floppy Disk
1 Do one of the following:
– To set RIP parameters, choose RIP from the Routing Protocols
menu and click Properties; continue with Step 2. The RIP
Configuration popup window appears as shown in Figure 130.
– To set OSPF parameters, choose OSPF from the Routing Protocols
menu and click Properties; skip to “OSPF Properties” on page
232.
Figure 130 RIP Configuration Popup Window
2 In the RIP Configuration popup window, if you want to turn on RIP for
IPX packets, click Enable under IPX RIP Enable; otherwise, continue
with the next step.