Enterasys Networks Network Card - Manual (Page 230)

218
RiverMaster Administrator’s Guide
Adding Remote Gateways Appendix B
ANG-3000/7000 Preconfiguration Stored on a Floppy Disk
Adding Remote Gateways
This section describes how to add a Remote ANG including its Name, IP
Address, User Name and Password and tunnel Protocol.
To add a Remote ANG, perform the following steps:
1 Open the Configuration pullout.
2 In the list of Aurorean devices, expand the tree list under Systems
(click the + symbol) and again under Remote Gateways as shown in
Figure 120.
Figure 120 Add Remote Gateway
3 Click Add Remote Gateway.
The Add Remote ANG window appears as shown in Figure 121.