Enterasys Networks Network Card - Manual (Page 54)

42
RiverMaster Administrator’s Guide
Viewing Aurorean Alternate Address Information Chapter 3
Configuring an ANG-3000/7000
NOTE
You must configure an IP address on your NAT Server that correlates
with the alias IP address you set here.
13 Click Apply to save your changes.
To return the parameters to their original settings without saving
your changes, click Reset.
14 Do one of the following:
– If you are setting up your Aurorean Virtual Network for the first
time, continue with the next subsection to configure additional
ANG network settings.
– If you are finished with the ANG network configuration and you
want to put the new network settings into effect, no additional
work is required.
Viewing Aurorean Alternate Address Information
The Aurorean Alternate Address Info window displays IP addresses of the
alternate APS and ANG systems, as well as those of the primary system.
To invoke the display, perform the following steps:
1 Open the Configuration pullout.
2 Click the arrow on the Configure toolbar item at the top left edge of
the pullout.
3 Choose Alt IP Addresses as shown in Figure 22.
The Aurorean Alternate Address Info window appears as shown in
Figure 22.
4 View the ANG and APS Primary and Secondary (if previously
configured) IP addresses.
NOTE
Primary addresses cannot be modified in this window.