Enterasys Networks Network Card - Manual (Page 229)

RiverMaster Administrator’s Guide
217
B
ANG-3000/7000 Preconfiguration Stored ANG-3000/7000 Preconfiguration Stored ANG-3000/7000 Preconfiguration Stored ANG-3000/7000 Preconfiguration Stored
on a Floppy Disk on a Floppy Disk on a Floppy Disk on a Floppy Disk
This appendix describes how to preconfigure the Aurorean Network
Gateway (ANG-3000/7000) using a floppy disk to store the configuration.
This procedure is similar to configuring the ANG using the RiverMaster
application. But this method allows an administrator to centrally configure
one or more gateways and conveniently distribute that configuration data on
floppy disks to remote sites.
When the floppy disk is inserted in the Remote ANG and the ANG rebooted,
configuration information stored in the
config.irx file is copied and the
ANG is ready to initiate tunnels. To enable the ANG to terminate tunnels.
please use the Aurorean Policy Manager as described in Chapter 3 of the
Aurorean Installation & Service Guide.
Also, any initiating ANG User configured here must later be added to the
User and Group database of the Local ANG. Refer to Chapter 6, “Managing
Users and Groups,” of this manual for instructions. ANG configuration with
a floppy disk is organized sequentially by the following categories:
H Adding Remote Gateways
H Configuring ANG IP Address
H Configuring Tunnel Protocols
H Configuring Virtual Subnets
H Configuring Routing Protocols
H Configuring Routing Interfaces
H Configuring Remote Connections
H Loading the Floppy Disk
Refer to Chapter 3 in the RiverMaster Administrator’s Guide for more detailed
information about the concepts underlying ANG configuration.