Enterasys Networks Network Card - Manual (Page 50)

38
RiverMaster Administrator’s Guide
General Aurorean Network Gateway Settings Chapter 3
Configuring an ANG-3000/7000
Figure 18 General Aurorean Network Gateway Settings
5 If you plan to change the Aurorean Network Gateway’s IP address in
the future, enter the new address in the Future IP Address field;
otherwise, leave this field blank and continue with the next step.
When you build a custom Aurorean Client installation kit for your
remote users (as described in Chapter 6), the ANG’s IP address is
saved as part of the kit. Aurorean Client needs this address to locate
the ANG across the Internet and create a tunnel. If you enter an IP
address in the Future IP Address field, the kit will contain both IP
addresses that appear on this pullout. If Aurorean Client cannot
locate a ANG by first using the standard IP address, it will
automatically use the future IP address. If connecting to this address
is unsuccessful, a user can enter an IP address in the Alternate Tunnel
Server IP address field in Aurorean Client. Refer to the Aurorean
Client User’s Guide for more information.
Click here to allow
remote users to
directly browse the
Internet while they
are tunneled into the
corporate network
The Aurorean Network Gateway IP address is set when
the servers are installed and displayed here as read-only