Setting routing protocol parameters, 1 open the configuration pullout, 3 expand the tree list under the name of your ang – Enterasys Networks Network Card User Manual
Page 67: 6 do one of the following, Setting rip properties
RiverMaster Administrator’s Guide
55
Chapter 3
Routing
Configuring an ANG-3000/7000
Setting Routing Protocol Parameters
To access RIP and OSPF parameters for the ANG, perform the following
steps:
1
Open the Configuration pullout.
2
In the list of Aurorean devices, expand the tree list under Servers
(click the + symbol).
3
Expand the tree list under the name of your ANG.
4
Click on Routing to display the routing parameter tab pages.
5
Click on the Protocols tab to display protocol parameters for RIP and
OSPF.
6
Do one of the following:
–
To set RIP parameters, choose RIP from the Routing Protocols
menu and click Properties; refer to the next section “Setting RIP
Properties” for additional instructions.
–
To set OSPF parameters, choose OSPF from the Routing Protocols
menu and click Properties; refer to “Setting OSPF Properties” on
page 57 for additional instructions.
Setting RIP Properties
To configure RIP properties for the ANG, perform the following steps:
1
Perform the steps in the previous section to access RIP properties.
The RIP Configuration window should appear as shown in Figure 31.