Enterasys Networks Network Card - Manual (Page 72)

60
RiverMaster Administrator’s Guide
Routing Chapter 3
Configuring an ANG-3000/7000
Figure 34 Aurorean Network Gateway Routing Interface Configuration
Adding or Removing a Routing Protocol for an Interface
To add or remove a routing protocol from an interface, perform the following
steps:
1 Open the Configuration pullout.
2 In the list of Aurorean devices, expand the tree list under Servers
(click the + symbol).
3 Expand the tree list under the name of your ANG.
4 Click on Routing to display the routing parameter tab pages.
5 Click on the Interfaces tab to display the configuration for each ANG
network interface.
Click here to
access the
Gateway
configuration
windows
Click here to
open the
Configuration
pullout