3 do one of the following, Figure 31 – Enterasys Networks Network Card User Manual
Page 68
56
RiverMaster Administrator’s Guide
Routing
Chapter 3
Configuring an ANG-3000/7000
Figure 31 RIP Routing Protocol Configuration
2
To turn on RIP for IPX packets, click Enable under IPX RIP Enable;
otherwise, continue with the next step.
3
Do one of the following:
–
To allow the ANG to accept RIP updates from all routers on the
same subnet, no further work is required. Skip to Step 6.
–
To configure “trusted” individual routers to supply RIP updates
to the ANG, click Add and continue with the next step.
The Add A Trusted Gateway window appears as shown in Figure 32.
Figure 32 Adding A Trusted Gateway for RIP
4
In the Address field, type the address for the router that the ANG will
accept updates from and click Add.
You can later modify this address or delete it using the Modify and
Remove buttons.
If this list is blank, the
Aurorean Network Gateway
accepts RIP updates from all
routers on the subnet. You
can limit the amount of
updates that the Aurorean
Network Gateway will accept
by specifying individual routers
in this list.