Enterasys Networks Network Card - Manual (Page 241)

RiverMaster Administrator’s Guide
229
Appendix B Configuring Virtual Subnets
ANG-3000/7000 Preconfiguration Stored on a Floppy Disk
1 Click Add.
The Add an IP Virtual Subnet popup window appears as shown in
Figure 128.
Figure 128 Add an IP Virtual Subnet Popup Window
2 Enter the starting address of the subnet in the Address fields.
You can use actual IP addresses from your network or non-routable
IP address ranges (such as 192.168.x.x for a Class C network).
3 Enter a subnet mask to define the subnet range in the Mask field.
4 Do one of the following:
– Click Add to add the new virtual subnet.
– Click Cancel to close the window without saving your changes.
5 Repeat previous steps for each virtual subnet you require.
6 Click Add to save your changes and Next to bring up the Routing
Configuration window as shown in Figure 129.
To return the parameters to their original settings without saving
your changes, click Reset.