Genicom microLaser 210 - Manual (Page 118)

Publication No. GEG-99054 Genicom Mar 00
6-4 microLaser 210 User Guide
Testing the Duplexer
4. Slide the tabs on the left and right sides of the duplexer into the channels inside the printer,
and push the duplexer completely into the printer.
5. Push the green tabs on the sides of the duplexer out toward the sides of the printer to secure
the duplexer to the printer.
6. Close the rear cover.
Testing the Duplexer
After installing the duplexer, use the following procedure to make sure it transports paper correctly:
1. Turn the printer on by pressing the [ I ] on the power switch on the right side of the printer.