About this chapter, About the envelope feeder, Installing the envelope feeder – Genicom microLaser 210 User Manual
Page 160: About the envelope feeder 8-2, Installing the envelope feeder 8-2
Publication No. GEG-99054
Genicom
Mar 00
8-2
microLaser 210 User Guide
About the Envelope Feeder
About this Chapter
This chapter provides all of the information necessary to install, use, and maintain the envelope
feeder, including procedures for removing paper jams.
About the Envelope Feeder
The Envelope Feeder is an optional single-tray feeder that attaches to the front of the printer. The
tray holds 50 to 100 envelopes or postcards, depending on the type of media.
Installing the Envelope Feeder
Before installing the envelope feeder, verify that you have received the following items in the ship-
ping box:
Installing the Envelope Feeder
Use the following procedure to install the envelope feeder:
1.
Turn the printer off by pressing [ O ] on the power switch on the right side of the unit, and
disconnect the power cord from the AC outlet.