System menu, System menu 3-13 – Genicom microLaser 210 User Manual

Page 57

Advertising
background image

Mar 00

Genicom

Publication No. GEG-99054

microLaser 210 User Guide

3-13

System Menu

System Menu

The system menu provides access to system settings. Use the following procedure to enter the sys-
tem menu:

1.

Press the MENU button on the control panel.

2.

Press the NEXT button until the text “System Menu” is shown on the second line of the dis-
play.

3.

Press the SELECT button to enter the system menu.

4.

Press the NEXT button to move through the submenus: Factory Defaults, Display Lan-
guage, Power Saver, Wait Timeout, Job Timeout, Jam Recovery, and Hex Print.

5.

Press the SELECT button to enter a submenu.

6.

Use the procedures in the following table to access and change the system settings:

Submenus

Default Setting

Available Settings

Procedure for Changing Setting

Factory Defaults
This submenu allows you to reset
the printer to U.S. or Non-U.S.
factory defaults.

U.S.

U.S.
Non-U.S.

1. Press NEXT or PREVIOUS to toggles

between U.S. and NON-U.S.

2. Press SELECT to choose and set

the factory defaults.

Display Language
This submenu allows you to change
the language of the display
messages.

English

English
French
German
Italian
Spanish

1. Press NEXT or PREVIOUS to scroll

through the available languages:
English, French (Francais), German
(Deutsch), Italian (Italiano), or
Spanish (Espanol).

2. Press SELECT to choose and set

the language.

Power Saver
This submenu allows you to set the
number of minutes the printer is
idle before it reverts to Power
Saver Mode.

15

0 - 999

1. Press NEXT or PREVIOUS to

increase or decrease the number of
minutes.

2. Press SELECT to save this setting.

Wait Timeout
This submenu allows you to
increase or decrease the length of
time (in seconds) that the printer
will remain in the waiting state—a
job is being processed, no
end-of-file has been detected, and
there is no more data to process.
This setting applies to both PCL
and PostScript print jobs.

20

0 - 99999

1. Press NEXT or PREVIOUS to

increase or decrease each digit of
the five-digit number.

2. Press SELECT set one digit and

move to the next digit.

3. Press SELECT after changing the

last digit to save this setting.

Job Timeout
This submenu allows you to
increase or decrease the time limit
(in seconds) for PostScript jobs. A
0 setting indicates no timeout. This
setting applies only to PostScript
jobs.

0

0 - 99999

1. Press NEXT or PREVIOUS to

increase or decrease each digit of
the five-digit number.

2. Press SELECT set one digit and

move to the next digit.

3. Press SELECT after changing the

last digit to save this setting.

Advertising