Genicom microLaser 210 - Manual (Page 54)

Publication No. GEG-99054 Genicom Mar 00
3-10 microLaser 210 User Guide
PS Menu
PS Menu
The PS Menu provides access to the PostScript settings. Use the following procedure to enter the
PS Menu:
1. Press the MENU button on the control panel.
2. Press the NEXT button until the text “PS Menu” is shown on the second line of the display.
3. Press the SELECT button to enter the PS menu.
4. Press the NEXT button to move through the submenus: Print PS Errors, and Manual Feed
TO.
5. Press the SELECT button to enter a submenu.
6. Use the procedures in the following table to access and change the PostScript settings:
Submenus Default
Setting Available Settings Procedure for Changing Settings
Print PS Errors
This submenu allows you
to choose to either print
or not print PS errors. Off On
Off 1. Press NEXT or PREVIOUS to toggle between ON
(print) and OFF (do not print).
2. Press SELECT to save this setting.
Manual Feed TO
This submenu allows you
to set the manual feed
timeout—the number of
seconds the printer
should wait for a manual
feed. A setting of 0 will
cause printer to wait
indefinitely for a manual
feed. 0 0 - 99999 1. Press NEXT or PREVIOUS to increase or
decrease each digit of the five-digit number.
2. Press SELECT to move to the next number.
3. Press SELECT after setting the last digit to save
the setting.