Genicom microLaser 210 - Manual (Page 37)

Mar 00 Genicom Publication No. GEG-99054
microLaser 210 User Guide 2-11
Loading the Universal Paper Tray
Print Media Weight, Type, and Size
The following table defines print media that you can use in each of the paper sources, and also indi-
cates the feed orientation—long edge feed (LEF) or short edge feed (SEF). If you have concerns
about a specific brand or type of media, try samples of the media to determine if the resulting
printer performance and print quality meet your expectations.
Loading the Universal Paper Tray
The 550-sheet universal paper tray has two width guides that are located on the sides of the tray,
and one length guide that is located near the center of the tray. These guides allow you to adjust the
size of the area that holds paper.
NOTE: The following procedure shows you how to load paper into the main paper tray. To load paper
into the optional 550 sheet paper feeder, simply complete the procedure using the 550 sheet
paper tray and feeder rather than the main paper tray.
Paper Source Meter Weight Paper Type and
Feed Direction Paper Sizes
Accommodated
Universal Paper Tray
(main tray and optional
550 sheet paper
feeder)
Do not use label stock
or other special media
in the 550 sheet paper
tray.
60 to 216g/m 2 Any paper Width:
98.4mm to 215.9mm
3.87 to 8.5 inches
Length:
148.5mm to 355.6mm
5.85 to 14 inches
A4 SEF 297 x 210mm
11.7 x 8.27 inches
Letter SEF 279.4 x 215.9mm
11 x 8.5 inches
Legal 13 inch 330.2 x 215.9mm
13 x 8.5 inches
Legal 14 inch 355.6 x 215.9mm
14 x 8.5 inches
Executive SEF 266.7 x 184.5mm
10.5 x 7.2 inches
A5 SEF 210 x 149mm
8.27 x 5.9 inches
B5 SEF 257 x 182mm
10.12 x 7.17 inches
Front Tray 60 to 216g/m
2
Envelopes
Transparencies
Labels
Postcards
Standard Paper (LEF
and SEF)
Other Paper Width:
3.0 to 8.5 inches
76.2mm to 215.9mm
Length:
5.0 to 14 inches
127mm to 355.6mm