Genicom microLaser 210 - Manual (Page 146)

Publication No. GEG-99054 Genicom Mar 00
7-18 microLaser 210 User Guide
Solving 550 Sheet Feeder Problems
1. Turn the printer off by pressing the [ O ] on the power switch on the right side of the printer.
2. Remove and then reinstall the feeder.
3. If the feeder is still inoperative after reinstallation, remove it from the printer so you can run
tests on the printer alone.
4. Print a few sheets of paper through the main paper tray or the front tray to make sure the
printer is still operational.
• If the printer is operational when the feeder is not attached, contact either your sales rep-
resentative or a service technician and report your problem.
• If the printer is not operational when the feeder is not attached, refer to Chapter 5: Trou-
bleshooting. After correcting the printer problem, return to Chapter 7: Using the 550
Sheet Feeder to reinstall the feeder.
Clearing an E2 Paper Jam
If an E2 error code precedes the error message on the first line of the control panel display, paper
has jammed somewhere between the paper source feed area and the toner cartridge. If you are using
the optional feeder as the current paper source, use the following procedure to clear a paper jam in
this location:
1. Remove any printed pages from the output tray.
2. Remove the paper tray from any optional feeders and from the printer, and inspect the inside
of the paper tray well, removing any jammed paper.
3. Remove any wrinkled or creased paper from the paper tray.