Genicom microLaser 210 - Manual (Page 157)

Mar 00 Genicom Publication No. GEG-99054
microLaser 210 User Guide 7-29
Moving the 550 Sheet Feeder
Moving the 550 Sheet Feeder
When moving the printer a short distance, you may leave the 550 sheet paper feeder attached.
However, when moving the printer a long distance, please remove the 550-sheet paper feeder to
avoid damaging either the printer or the feeder.
Moving the Printer and 550 Sheet Feeder a Short Distance
Use the following procedure to move the printer and 550 sheet feeder a short distance:
1. Turn the printer off by pressing the [ O ] on the power switch on the back of the printer.
2. Unplug the AC power cord from the AC wall outlet.
3. Disconnect the printer from the host computer.
4. Wait 30 minutes for the printer to cool.
5. Remove the toner cartridge and cover it with an opaque plastic sheet.
6. With the help of another person, carefully lift the printer and attached 550 sheet feeder and
move them to the new location.
7. Once the printer is in the new location, refer to the Installation Guide included in the origi-
nal printer packaging to reinstall the printer.
Moving the Printer and 550 Sheet Feeder a Long Distance
Use the following procedure to move the printer and 550 sheet feeder a long distance:
1. Turn the printer off by pressing the [ O ] on the power switch on the right side of the printer.
2. Unplug the AC power cord from the wall outlet and from the back of the printer.
3. Disconnect the printer from the host computer.
4. Remove the paper from all of the paper trays.
5. Wait 30 minutes for the printer to cool.
6. Remove the main paper tray.
7. Reach inside the open top tray and locate the two thumbscrews that are at the front left and
front right of the feeder.
8. Unscrew the two thumbscrews to release the feeder from the printer.
9. Lift the printer off of the 550 sheet feeder and place it on the floor or on a table.
10. Repack the feeder in the original shipping box.
11. Remove the toner cartridge and place it in an opaque plastic bag, then seal the bag with tape
and place it in a sturdy box.
12. Repack the printer, paper trays, AC power cord and toner cartridge into the original shipping
box or boxes.
13. Once the feeder is in the new location, refer to“Installing the 550 Sheet Paper Feeders” on
page 3 to reinstall the paper feeder(s).
◆ ◆ ◆