Genicom microLaser 210 - Manual (Page 184)

Publication No. GEG-99054 Genicom Mar 00
9-12 microLaser 210 User Guide
Solving Offset Catch Tray Problems
Clearing an Offset Catch Tray Paper Jam
If an E6 error code precedes the error message on the first line of the control panel display, paper
has jammed at the offset catch tray. Use the following procedure to clear a paper jam in this loca-
tion:
1. Pull on the recessed area on the rear of the offset catch tray to open the rear cover.
2. Remove any jammed paper from the interior of the offset catch tray.
3. Close the rear cover of the offset catch tray.
4. Squeeze the latch on the upper part of the rear cover, and pull the cover toward you to open
it. Remove any paper that is stuck behind the rear cover.