Removing the face up tray, Removing the face up tray 10-6 – Genicom microLaser 210 User Manual

Page 196

Advertising
background image

Publication No. GEG-99054

Genicom

Mar 00

10-6

microLaser 210 User Guide
Removing the Face Up Tray

10.

Close the rear cover.

Removing the Face Up Tray

Use the following procedure to remove the face up tray:

1.

Turn the printer off by pressing [ O ] on the power switch on the front left of the printer, and
disconnect the power cord from the AC outlet.

NOTE:

Installing the face up tray while the printer is on may damage the printer or the face up tray.

2.

Squeeze the latch on the top left of the rear cover to release the cover, then open the rear cover
by pulling down on the top of the cover.

Advertising