Genicom microLaser 210 User Manual

Page 43

Advertising
background image

Mar 00

Genicom

Publication No. GEG-99054

microLaser 210 User Guide

2-17

Loading the Front Tray

4.

Stack the paper that you will load in the front tray, making sure that the edges are aligned and
neat. Position the paper stack so the surface to be printed faces up.

5.

Load the stack of paper into the front tray by sliding the stack between the paper guides and
then pushing the paper stack into the tray until it will not go any further.

6.

Check the paper stack to make sure it is not loaded at an angle and that the guides barely
touch the stack.

◆ ◆ ◆

CAUTION: Do not press the guides tightly against the stack; the guides should just barely
touch the stack of paper. Paper guides that are too tight can cause feed jams.

Advertising