Genicom microLaser 210 - Manual (Page 165)

Mar 00 Genicom Publication No. GEG-99054
microLaser 210 User Guide 8-7
Solving Envelope Feeder Problems
3. Lower the paper holder.
4. Adjust the paper guide to the size of the envelopes or postcards you are using.
Solving Envelope Feeder Problems
When there is a problem with the envelope feeder, the printer control panel displays an error code
and error message. Most envelope feeder error codes indicate routine status conditions such as run-
ning out of paper or a paper jam. Some error codes indicate much more serious problems that may
require the help of a service technician.
■ If the printer control panel displays an error message or an error code, refer to “Interpreting
Envelope Feeder Error Messages” on page 8-10.
■ If you have an envelope feeder problem but the printer control panel does not display an error
message or error code, refer to “Correcting Miscellaneous Envelope Feeder Problems” on
page 8-10 and follow the directions for correcting that problem.
Envelopes Become Creased when Printing
If envelopes are creased or wrinkled after printing, lift up the fuser release levers at the left and right
side of the fuser unit, and try printing again. The printed image may appear thin using this
method, but the envelopes will not be creased or wrinkled.
Use the following procedure to lift the fuser release levers: