Genicom microLaser 210 - Manual (Page 29)

Mar 00 Genicom Publication No. GEG-99054
microLaser 210 User Guide 2-3
Turning Power On and Off
Turning Power On and Off
Use the following procedure to turn the printer on:
1. Turn the printer on by pressing [ I ] on the power switch on the left front of the printer.
The status message “Loading” appears on the display. This message indicates that the printer
is warming up and is not ready to print. After about 65 seconds, the status message changes
to “Ready”, indicating that the printer is ready to print.
NOTE: If an error message appears on the display after you turn the printer on, refer to “Warning
Messages and Error Messages” on page 3-2.
Use the following procedure to turn the printer off:
1. Turn the printer off by pressing the [ O ] on the power switch on the right side of the printer.
Ready Loading