Toshiba MMU-AP0121MH - Manual (Page 12)

12
Operation section
Push each button to select a desired operation.
This remote controller can operate the maximum 8 indoor units.
• The details of the operation needs to be set up once, afterward, the air conditioner can be used by pushing
ON / OFF
button only.
1
Air volume select button
Selects the desired air volume mode.
2
Timer set button
TIMER SET button is used when the timer is set
up.
3
Check button
The CHECK button is used for the check opera-
tion. During normal operation, do not use this
button.
4
Fan button
FAN button is used when a fan which is sold on
the market or etc. is connected.
5
Filter reset button
Resets (Erases) “FILTER ” display.
6
Wind direction and Swing
UNIT :
If the multiple indoor units are operated by only
one remote controller, select the units when the
air direction is adjusted.
SWING/FIX :
Set up the auto swing and angle of the flap.
7
Operation lamp
Lamp is lit during the operation. Lamp is off when
stopped.
Although it flashes when operating the protection
device or abnormal time.
8 ON / OFF
button
When the button is pushed, the operation starts,
and it stops by pushing the button again.
When the operation has stopped, the operation
lamp and all the displays disappear.
9
Operation select button
Selects desired operation mode.
10
Set up temperature button
Adjusts the room temperature.
Set the desired set temperature by pushing
or .
OPTION :
Remote controller sensor
Usually the TEMP. sensor of the indoor unit senses
the temperature. The temperature on the surround-
ing of the remote controller can also be sensed.
For details, contact the dealer from which you have
purchased the air conditioner.
• In case that one remote controller controls the
multiple indoor units, the setup operation is
unavailable in group control.
1 7
3
5
2
8
9
6
4
10
ON / OFF
FAN
TEMP.
SWING/FIX TIME
MODE
VENT
UNIT SET CL
FILTER
RESET TEST
TIMER SET