Philips HR7755 - Manual (Page 6)

ENGLISH 6
Introduction
This appliance is equipped with an automatic
thermal cut-out system.This system will
automatically cut off the power supply to the
appliance in case of overheating.
General description
A Motor unit
B Speed control
- P= pulse
- 0 = off
- 1 = lowest speed
- 2 = highest speed
C Screw cap (must be placed to be able to use
food-processing functions)
D Food processing bowl
E Tool holder
F Lid of food processing bowl
G Blender jar
H Blender jar lid
I Feed tube
J Pusher
K Stopper
L Kneading accessory
M Metal blade + protective cover
N Slicing insert medium
O Shredding insert medium
P Insert holder
Q Emulsifying disc
R Gear housing meat mincer
S Cutter housing meat mincer
T Worm shaft
U Screw ring
V Cutter unit
W Medium grinding disc, 4 mm dia.
X Coarse grinding disc, 8 mm dia.
Y Separator
Z Sausage horn
a Tray
b Pusher
c Release lever
Important
Read these instructions for use carefully before
using the appliance and save them for future
reference.
◗ Check if the voltage indicated on the
appliance corresponds to the local mains
voltage before you connect the appliance.
◗ Never use any accessories or parts from
other manufacturers or that have not been
specifically advised by Philips.Your guarantee
will become invalid if such accessories or
parts have been used.
◗ In order to avoid a hazardous situation, this
appliance must never be connected to a timer
switch.
◗ Do not use the appliance if the mains cord,
the plug or other parts are damaged.
◗ If the mains cord is damaged, it must be
replaced by Philips, a service centre
authorised by Philips or similarly qualified
persons in order to avoid a hazard.