QTECH QSW-3400 Инструкция по настройке - Manual (Page 115)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
114
(2) Configure the enable state of the transceiver monitoring
(3) Show the information of the transceiver monitoring
(4) Clear the information of the transceiver monitoring
14.3 Examples of DDM
Example1:
Ethernet 21 and Ethernet 23 are inserted the fiber module with DDM, Ethernet 24 is inserted
transceiver-monitoring interval <minutes>
no transceiver-monitoring interval
Set the interval of the transceiver
monitor. The no command sets the
interval to be the default interval of 15
minutes.
Command Explanation
Port mode
transceiver-monitoring {enable | disable} Set whether the transceiver monitoring
is enabled. Only the port enables the
transceiver monitoring, the system
records the abnormity state. After the
port disables the function, the
abnormity information will be clear.
Command Explanation
Admin mode and global mode
show transceiver threshold-violation [interface
ethernet <interface-list>]
Show the information of the transceiver
monitoring, including the last threshold-
violation informatijon, the interval of the
current transceiver monitoring and
whether the port enables the
transceiver monitoring.
Command Explanation
Admin mode
clear transceiver threshold-violation [interface
ethernet <interface-list>]
Clear the threshold violation of the
transceiver monitor.