QTECH QSW-3400 Инструкция по настройке - Manual (Page 259)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
258
configured.
ipv6 dhcp class <class-name>
no ipv6 dhcp class <class-name>
This command defines a
DHCPv6 class and enters
DHCPv6 class mode, the no
form of this command removes
this DHCPv6 class.
Interface configuration mode
ipv6 dhcp server select relay-forw
no ipv6 dhcp server select relay-forw
This command enables the
DHCPv6 server to support
selections when multiple option
37 or option 38 options exist and
the option 37 and option 38 of
relay-forw in the innermost layer
are selected. The no operation of
it restores the default
configuration, i.e. selecting
option 37 and option 38 of the
original packets.
IPv6 DHCP Class configuration mode
{remote-id [*] <remote-id> [*] | subscriber-id [*]
<subscriber-id> [*]}
no {remote-id [*] <remote-id> [*] | subscriber-id [*]
<subscriber-id> [*]}
This command configures option
37 and option 38 that match the
class in ipv6 dhcp class
configuration mode.
DHCPv6 address pool configuration mode
class <class-name>
no class <class-name>
This command associates class
to address pool in DHCPv6
address pool configuration mode
and enters class configuration
mode in address pool. Use no
command to remove the link.
address range <start-ip> <end-ip>
no address range <start-ip> <end-ip>
This command is used to set
address range for a DHCPv6
class in DHCPv6 address pool
configuration mode, the no
command is used to remove the
addreass range. The prefix/plen
form is not supported.