QTECH QSW-3400 Инструкция по настройке - Manual (Page 429)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
428
much more flexible.
The normal mode configuration is show as below:
Solution 1:
Source switch:
Interface ethernet 1/1 is the source port for mirroring.
Interface ethernet 1/2 is the destination port which is connected to the intermediate switch.
RSPAN VLAN is 5.
Switch(config)#vlan 5
Switch(Config-Vlan5)#remote-span
Switch(Config-Vlan5)#exit
Switch(config)#interface ethernet 1/2
Switch(Config-If-Ethernet1/2)#switchport mode trunk
Switch(Config-If-Ethernet1/2)#exit
Switch(config)#monitor session 1 source interface ethernet1/1 rx
Switch(config)#monitor session 1 destination interface ethernet1/2
Switch(config)#monitor session 1 remote vlan 5
Intermediate switch:
Interface ethernet1/6 is the source port which is connected to the source switch.
Interface ethernet1/7 is the destination port which is connected to the intermediate switch. The
native VLAN of this port cannot be configured as RSPAN VLAN, or the mirrored data may not
be carried by the destination switch.
RSPAN VLAN is 5.
Switch(config)#vlan 5
Switch(Config-Vlan5)#remote-span
Switch(Config-Vlan5)#exit
Switch(config)#interface ethernet 1/6-7
Switch(Config-If-Port-Range)#switchport mode trunk
Switch(Config-If-Port-Range)#exit
Destination switch:
Interface ethernet1/9 is the source port, which is connected to the source switch.
Interface ethernet1/10 is the destination port which is connected to the monitor. This port is
required to be configured as an access port, and belong to the RSPAN VLAN.
RSPAN VLAN is 5.