QTECH QSW-3400 Инструкция по настройке - Manual (Page 169)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
168
19.5.1.3 Binding MAC Address Binding Troubleshooting
Enabling MAC address binding for ports may fail in some occasions. Here are some possible
causes and solutions:

If MAC address binding cannot be enabled for a port, make sure the port is not
enabling port aggregation and is not configured as a Trunk port. MAC address binding
is exclusive to such configurations. If MAC address binding is to be enabled, the
functions mentioned above must be disabled first.

If a secure address is set as static address and deleted, that secure address will be
unusable even though it exists. For this reason, it is recommended to avoid static
address for ports enabling MAC address.
19.6 MAC Notification Configuration
19.6.1 Introduction to MAC Notification
MAC Notification function depends on the notification. Add or remove the MAC address,
namely, when the device is added or removed, it will notify administrator about the changing by
the trap function of snmp.
19.6.2 MAC Notification Configuration
Mac notification configuration task list:
1. Configure the global snmp MAC notification
2. Configure the global MAC notification
3. Configure the interval for sending MAC notification
4. Configure the size of history table
5. Configure the trap type of MAC notification supported by the port
6. Show the configuration and the data of MAC notification
7. Clear the statistics of MAC notification trap
1. Configure the global snmp MAC notification
2. Configure the global MAC notification
Command Explanation
Global mode
snmp-server enable traps mac-notification
no snmp-server enable traps mac-notification
Configure or cancel the global snmp
MAC notification.
Command Explanation