QTECH QSW-3400 Инструкция по настройке - Manual (Page 30)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
29
1.2.1.5 VLAN Mode
Using the vlan <vlan-id> command under Global Mode can enter the corresponding VLAN
Mode. Under VLAN Mode the user can configure all member ports of the corresponding VLAN.
Run the exit command to exit the VLAN Mode to Global Mode.
1.2.1.6 DHCP Address Pool Mode
Type the ip dhcp pool <name> command under Global Mode will enter the DHCP Address
Pool Mode prompt “Switch(Config-<name>-dhcp)#”. DHCP address pool properties can be
configured under DHCP Address Pool Mode. Run the exit command to exit the DHCP Address
Pool Mode to Global Mode.
1.2.1.7 ACL Mode
ACL type Entry Operates Exit
Standard IP
ACL Mode
Type ip access-list
standard command under
Global Mode.
Configure parameters for
Standard IP ACL Mode.
Use the exit
command to return
to Global Mode.
Extended IP
ACL Mode
Type ip access-list
extanded command under
Global Mode.
Configure parameters for
Extended IP ACL Mode.
Use the exit
command to return
to Global Mode.
1.2.2 Configuration Syntax
Switch provides various configuration commands. Although all the commands are different,
they all abide by the syntax for Switch configuration commands. The general commands
format of Switch is shown below:
cmdtxt <variable> {enum1 | … | enumN } [option1 | … | optionN]
Conventions: cmdtxt in bold font indicates a command keyword; <variable> indicates a
variable parameter;
{enum1 | … | enumN } indicates a mandatory parameter that should be
selected from the parameter set enum1~enumN; and the square bracket ([ ]) in [option1 | … |
optionN] indicate an optional parameter. There may be combinations of “< >“, “{ }” and “[ ]” in
the command line, such as [<variable>], {enum1 <variable>| enum2}, [option1 [option2]],
etc.
Here are examples for some actual configuration commands:

show version, no parameters required. This is a command with only a keyword and no
parameter, just type in the command to run.

vlan <vlan-id>, parameter values are required after the keyword.