QTECH QSW-3400 Инструкция по настройке - Manual (Page 456)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
455
logging buffered command. To clear the log save in NVRAM and SDRAM log buffer zone, we
can use the clear logging command.
64.7.2 System Log Configuration
System Log Configuration Task Sequence:
1. Display and clear log buffer zone
2. Configure the log host output channel
3. Enable/disable the log executed-commands
4. Display the log source
5. Display executed-commands state
1. Display and clear log buffer zone
Command Description
Admin Mode
show logging buffered [ level {critical | warnings} |
range <begin-index> <end-index>]
Show detailed log information in the
log buffer channel.
clear logging sdram Clear log buffer zone information.
2. Configure the log host output channel
Command Description
Global Mode
logging {<ipv4-addr> | <ipv6-addr>} [ facility <local-
number> ] [level <severity>]
no logging {<ipv4-addr> | <ipv6-addr>} [ facility
<local-number>]
Enable the output channel of the log
host. The “no” form of this command
will disable the output at the output
channel of the log host.
logging loghost sequence-number
no logging loghost sequence-number
Add the loghost sequence-number
for the log, the no command does not
include the loghost sequence-
number.
3. Enable/disable the log executed-commands
Command Description
Global mode
logging executed-commands {enable | disable}
Enable or disable the logging
executed-commands