QTECH QSW-3400 Инструкция по настройке - Manual (Page 152)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
151
4. Configure the IP-subnet-based VLAN function on the port
5. Configure the correspondence between the IP subnet and the VLAN
6. Configure the correspondence between the Protocols and the VLAN
7. Adjust the priority of the dynamic VLAN
Command Explanation
Global Mode
mac-vlan mac <mac-addrss> vlan <vlan-id>
priority <priority-id>
no mac-vlan {mac <mac-addrss>|all}
Add/delete the correspondence between
the MAC address and the VLAN, namely
specified MAC address join/leave specified
VLAN.
Command Explanation
Port Mode
switchport subnet-vlan enable
no switchport subnet-vlan enable
Enable/disable the port IP-subnet-base
VLAN function on the port.
Command Explanation
Global Mode
subnet-vlan ip-address <ipv4-addrss> mask
<subnet-mask> vlan <vlan-id> priority
<priority-id>
no subnet-vlan {ip-address <ipv4-addrss>
mask <subnet-mask>|all}
Add/delete the correspondence between
the IP subnet and the VLAN, namely
specified IP subnet joins/leaves specified
VLAN.
Command Explanation
Global Mode
protocol-vlan mode {ethernetii etype <etype-
id>|llc {dsap <dsap-id> ssap <ssap-id>}|snap
etype <etype-id>} vlan <vlan-id> priority
<priority-id>
no protocol-vlan {mode {ethernetii etype
<etype-id>|llc {dsap <dsap-id> ssap <ssap-
id>}|snap etype <etype-id>}|all}
Add/delete the correspondence between
the Protocols and the VLAN, namely
specified protocol joins/leaves specified
VLAN.
Command Explanation