QTECH QSW-3400 Инструкция по настройке - Manual (Page 302)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
301
(1) Enable global packet filtering function
(2) Configure default action
3. Configuring time range function
(1) Create the name of the time range
(2) Configure periodic time range
(3) Configure absolute time range
4. Bind access-list to an incoming direction of the specified port
5. Clear the filtering information of the specified port
1. Configuring access-list
(1) Configuring a numbered standard IP access-list
Command Explanation
Global Mode
access-list <num> {deny | permit} {{<sIpAddr>
<sMask>} | any-source | {host-source <sIpAddr>}}
no access-list <num>
Creates a numbered standard IP
access-list, if the access-list
already exists, then a rule will add
to the current access- list; the “no
access-list <nu m>“ command
deletes a numbered standard IP
access-list.
(2) Configuring a numbered extensive IP access-list
Command Explanation
Global Mode
access-list <num> {deny | permit} icmp {{<sIpAddr>
<sMask>} | any-source | {host-source <sIpAddr>}}
{{<dIpAddr> <dMask>} | any-destination | {host-
destination <dIpAddr>}} [<icmp-type> [<icmp-code>]]
[precedence <prec>] [tos <tos>][time-range<time-
range-name>]
Creates a numbered ICMP
extended IP access rule; if the
numbered extended access-list of
specified number does not exist,
then an access-list will be created
using this number.
access-list <num> {deny | permit} igmp {{<sIpAddr>
<sMask>} | any-source | {host-source <sIpAddr>}}
{{<dIpAddr> <dMask>} | any-destination | {host-
destination <dIpAddr>}} [<igmp-type>] [precedence
<prec>] [tos <tos>][time-range<time-range-name>]
Creates a numbered IGMP
extended IP access rule; if the
numbered extended access-list of
specified number does not exist,
then an access-list will be created
using this number.
access-list <num> {deny | permit} tcp {{<sIpAddr> Creates a numbered TCP