QTECH QSW-3400 Инструкция по настройке - Manual (Page 392)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
391
no savi max-dad-prepare-delay restores the default value.
6. Configure the global max-slaac-life for SAVI
Command Explanation
Global mode
savi max-slaac-life <max-slaac-life>
no savi max-slaac-life
Configure the lifetime period of the dynamic
slaac binding at BOUND state, no command
restores the default value.
7. Configure the lifetime period for SAVI bind-protect
Command Explanation
Global mode
savi timeout bind-protect <protect-time>
no savi timeout bind-protect
Configure the bind-protect lifetime period to a
port after its state from up to down, no
command restores the default value.
8. Enable or disable SAVI prefix check function
Command Explanation
Global mode
ipv6 cps prefix check enable
no ipv6 cps prefix check enable
Enable the address prefix check for SAVI, no
command disables the function.
9. Configure IPv6 address prefix for a link
Command Explanation
Global mode
ipv6 cps prefix <ip-address> vlan <vid>
no ipv6 cps prefix <ip-address>
Configure IPv6 address prefix for a link
manually, no command deletes the
configured address prefix.
10. Configure the filter entry number of IPv6 address
Command Explanation
Global mode
savi ipv6 mac-binding-limit <limit-num>
no savi ipv6 mac-binding-limit
Configure the corresponding dynamic binding
number for the same MAC address, no
command restores the default value. Note:
The binding number only limits the dynamic