QTECH QSW-3400 Инструкция по настройке - Manual (Page 71)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
70
{ bcast|mcast|ucast }
no switchport flood-control
{ bcast|mcast|ucast }
broadcast, unknown multicast or unknown
unicast packets any more to the specified port;
no command restores the default configuration.
Note: This switch does not support this
command.
port-scan-mode {interrupt | poll}
no port-scan-mode
Configure port-scan-mode as interrupt or poll
mode, the no command restores the default
port-scan-mode.
rate-violation <200-2000000> [recovery
<0-86400>]
no rate-violation
Set the max packet reception rate of a port. If
the rate of the received packet violates the
packet reception rate, shut down this port and
configure the recovery time, the default is 300s.
The no command will disable the rate-violation
function of a port.
Command Explanation
Port Mode
switchport discard packet { all | untag }
no switchport discard packet { all |
untag }
Configure the port not to receive any packet or
untag; the no command cancel the restriction of
discard, it means the port is allowed to receive
any packet or untag.
Command Explanation
Global Mode
port-rate-statistics interval <interval -
value>
Configure the interval of port-rate-statistics.
3. Virtual cable test
Command Explanation
Admin Mode
virtual-cable-test interface ethernet
<interface-list>
Test virtual cables of the port.