QTECH QSW-3400 Инструкция по настройке User Manual
Page 303
+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
302
<sMask>} | any-source | {host-source <sIpAddr>}} [s-
port {<sPort> | range <sPortMin> <sPortMax>}]
{{<dIpAddr> <dMask>} | any-destination | {host-
destination <dIpAddr>}} [d-port {<dPort> | range
<dPortMin> <dPortMax>}] [ack+fin+psh+rst+urg+syn]
[precedence <prec>] [tos <tos>][time-range<time-
range-name>]
extended IP access rule; if the
numbered extended access-list of
specified number does not exist,
then an access-list will be created
using this number.
access-list <num> {deny | permit} udp {{<sIpAddr>
<sMask>} | any-source | {host-source <sIpAddr>}} [s-
port {<sPort> | range <sPortMin> <sPortMax>}]
{{<dIpAddr> <dMask>} | any-destination | {host-
destination <dIpAddr>}} [d-port {<dPort> | range
<dPortMin> <dPortMax>}] [precedence <prec>] [tos
<tos>][time-range<time-range-name>]
Creates
a
numbered
UDP
extended IP access rule; if the
numbered extended access-list of
specified number does not exist,
then an access-list will be created
using this number.
access-list <num> {deny | permit} {eigrp | gre | igrp |
ipinip | ip | ospf | <protocol-num>} {{<sIpAddr>
<sMask>} | any-source | {host-source <sIpAddr>}}
{{<dIpAddr> <dMask>} | any-destination | {host-
destination <dIpAddr>}} [precedence <prec>] [tos
<tos>][time-range<time-range-name>]
Creates a numbered IP extended
IP access rule for other specific IP
protocol or all IP protocols; if the
numbered extended access-list of
specified number does not exist,
then an access-list will be created
using this number.
no access-list <num>
Deletes a numbered extensive IP
access-list.
(3) Configuring a standard IP access-list basing on nomenclature
1) Create a name-based standard IP access-list
Command
Explanation
Global Mode
ip access-list standard <name>
no ip access-list standard <name>
Creates a standard IP access-
list based on nomenclature; the
“no ip access-list standard
<name>“ command deletes the
name-based
standard
IP
access-list.
2)
Specify multiple “permit” or “deny” rules
Command
Explanation