QTECH QSW-3400 Инструкция по настройке - Manual (Page 343)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
342
switchport arp dynamic maximum <value>
no switchport arp dynamic maximum
Enable and disable the number limitation
function of ARP on the ports.
switchport nd dynamic maximum <value>
no switchport nd dynamic maximum
Enable and disable the number limitation
function of ND on the ports.
2. Enable the number limitation function of MAC and IP in VLAN
Command Explanation
VLAN configuration mode
vlan mac-address dynamic maximum
<value>
no vlan mac-address dynamic maximum
Enable and disable the number limitation
function of MAC in the VLAN.
Interface configuration mode
ip arp dynamic maximum <value>
no ip arp dynamic maximum
Enable and disable the number limitation
function of ARP in the VLAN.
ipv6 nd dynamic maximum <value>
no ipv6 nd dynamic maximum
Enable and disable the number limitation
function of NEIGHBOR in the VLAN.
3. Configure the timeout value of querying dynamic MAC
Command Explanation
Global configuration mode
mac-address query timeout <seconds>
Configure the timeout value of querying
dynamic MAC.
3. Configure the violation mode of ports
Command Explanation
Port mode
switchport mac-address violation {protect |
shutdown} [recovery <5-3600>]
no switchport mac-address violation
Set the violation mode of the port, the no
command restores the violation mode to
protect.
6. Display and debug the relative information of number limitation of MAC and IP on ports
Command Explanation
Admin mode
show mac-address dynamic count {vlan
<vlan-id> | interface ethernet
<portName> }
Display the number of dynamic MAC in
corresponding ports and VLAN.
show arp-dynamic count {vlan Display the number of dynamic ARP in