QTECH QSW-3400 Инструкция по настройке - Manual (Page 404)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
403
Switch(config-If-Ethernet1/2)#mrpp ring 4000 secondary-port
Switch(config-If-Ethernet1/2)#exit
Switch(Config)#
53.4 MRPP Troubleshooting
The normal operation of MRPP protocol depends on normal configuration of each switch on
MRPP ring, otherwise it is very possible to form ring and broadcast storm:
 Configuring MRPP ring, you’d better disconnected the ring, and wait for each switch
configuration, then open the ring.

When the MRPP ring of enabled switch is disabled on MRPP ring, it ensures the ring of
the MRPP ring has been disconnected.

When there is broadcast storm on MRPP ring, it disconnects the ring firstly, and
ensures if each switch MRPP ring configuration on the ring is correct or not; if correct,
restores the ring, and then observes the ring is normal or not.

The convergence time of MRPP ring net is relative to the response mode of up/down. If
use poll mode, the convergence time as hundreds of milliseconds in simple ring net, if
use interrupt mode, the convergence time within 50 milliseconds.

Generally, the port is configured as poll mode, interrupt mode is only applied to better
performance environment, but the security of poll mode is better than interrupt mode,
port-scan-mode {interrupt | poll} command can be consulted.

In normal configuration, it still forms ring broadcast storm or ring block, please open
debug function of primary node MRPP, and used show MRPP statistics command to
observe states of primary node and transfer node and statistics information is normal
or not, and then sends results to our Technology Service Center.