QTECH QSW-3400 Инструкция по настройке - Manual (Page 214)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
213
anti-arpscan recovery time <seconds>
no anti-arpscan recovery time
Set automatic recovery time.
6. Display relative information of debug information and ARP scanning
Command Explanation
Global configuration mode
anti-arpscan log enable
no anti-arpscan log enable
Enable or disable the log function of ARP
scanning prevention.
anti-arpscan trap enable
no anti-arpscan trap enable
Enable or disable the SNMP Trap function of
ARP scanning prevention.
show anti-arpscan [trust <ip | port |
supertrust-port> | prohibited <ip | port>]
Display the state of operation and
configuration of ARP scanning prevention.
Admin Mode
debug anti-arpscan <port | ip>
no debug anti-arpscan <port | ip>
Enable or disable the debug switch of ARP
scanning prevention.
25.3 ARP Scanning Prevention Typical Examples
ARP scanning prevention typical configuration example
In the network topology above, port E1/1 of SWITCH B is connected to port E1/19 of SWITCH
A, the port E1/2 of SWITCH A is connected to file server (IP address is 192.168.1.100/24), and
all the other ports of SWITCH A are connected to common PC. The following configuration can
prevent ARP scanning effectively without affecting the normal operation of the system.
SWITCH A configuration task sequence:
SWITCH A
SWITCH B
PC PC
E1/1
E1/19
E1/
2
Server
192.168.1.100/2
4
E1/2