QTECH QSW-3400 Инструкция по настройке - Manual (Page 23)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
22
Switch#config
Switch(config)#interface vlan 1
Switch(Config-if-Vlan1)#ip address 10.1.128.251 255.255.255.0
Switch(Config-if-Vlan1)#no shutdown
To enable the Telnet Server function, users should type the CLI command telnet-server enable
in the global mode as below:
Switch>enable
Switch#config
Switch(config)# telnet-server enable
Step 2: Run Telnet Client program.
Run Telnet client program included in Windows with the specified Telnet target.
Run telnet client program included in Windows
Step 3: Login to the switch.
Login to the Telnet configuration interface. Valid login name and password are required,
otherwise the switch will reject Telnet access. This is a method to protect the switch from
unauthorized access. As a result, when Telnet is enabled for configuring and managing the
switch, username and password for authorized Telnet users must be configured with the
following command: username <username> privilege <privilege> [password (0|7) <password>].
To open the local authentication style with the following command: authentication line vty login
local. Privilege option must exist and just is 15. Assume an authorized user in the switch has a
username of “test”, and password of “test”, the configuration procedure should like the
following:
Switch>enable
Switch#config