QTECH QSW-3400 Инструкция по настройке - Manual (Page 459)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
458
Chapter 66 Debugging and Diagnosis for
Packets Received and Sent by CPU
66.1 Introduction to Debugging and Diagnosis for Packets
Received and Sent by CPU
The following commands are used to debug and diagnose the packets received and sent by
CPU, and are supposed to be used with the help of the technical support.
66.2 Debugging and Diagnosis for Packets Received and Sent by
CPU Task List
Command Explanation
Global Mode
cpu-rx-ratelimit protocol
<protocol-type> <packets>
no cpu-rx-ratelimit protocol
[ <protocol- type> ]
Set the max rate of the CPU receiving packets of the
protocol type, the no command set the max rate to default.
clear cpu-rx-stat protocol
[ <protocol-type> ]
Clear the statistics of the CPU received packets of the
protocol type.
Admin Mode
show cpu-rx protocol
[ <protocol-type> ]
Show the information of the CPU received packets of the
protocol type.
debug driver {receive|send}
[interface {<interface-name>
|all}] [protocol {<protocol-
type> |discard |all}][detail]
Turn on the showing of the CPU receiving or sending
packet informations.
no debug driver {receive
|send}
Turn off the showing of the CPU receiving or sending
packet informations.