QTECH QSW-3400 Инструкция по настройке - Manual (Page 39)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
38

BOOTP

DHCP
Manual configuration of IP address is assign an IP address manually for the switch.
In BOOTP/DHCP mode, the switch operates as a BOOTP/DHCP client, send broadcast
packets of BOOTPRequest to the BOOTP/DHCP servers, and the BOOTP/DHCP servers
assign the address on receiving the request. In addition, switch can act as a DHCP server, and
dynamically assign network parameters such as IP addresses, gateway addresses and DNS
server addresses to DHCP clients DHCP Server configuration is detailed in later chapters.
2.3.1 Switch IP Addresses Configuration Task List
1. Enable VLAN port mode
Manual configuration
BOOTP configuration
DHCP configuration
1. Enable VLAN port mode
Command Explanation
Global Mode
interface vlan <vlan-id>
no interface vlan <vlan-id>
Create VLAN interface (layer 3 interface); the
no command deletes the VLAN interface.
Manual configuration
Command Explanation
VLAN Interface Mode
ip address <ip_address> <mask>
[secondary]
no ip address <ip_address> <mask>
[secondary]
Configure IP address of VLAN interface; the
no command deletes IP address of VLAN
interface.
ipv6 address <ipv6-address / prefix-
length> [eui-64]
no ipv6 address <ipv6-address / prefix-
length>
Configure IPv6 address, including aggregation
global unicast address, local site address and
local link address. The no command deletes
IPv6 address.
BOOTP configuration
Command Explanation
VLAN Interface Mode
ip bootp-client enable Enable the switch to be a BootP client and