3 basic qos model – QTECH QSW-3400 Инструкция по настройке User Manual

Page 186

Advertising
background image

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1

185

Based on differentiated service, QoS specifies a priority for each packet at the ingress. The

classification information is carried in Layer 3 IP packet header or Layer 2 802.1Q frame

header. QoS provides same service to packets of the same priority, while offers different

operations for packets of different priority. QoS-enabled switch or router can provide different

bandwidth according to the packet classification information, and can remark on the

classification information according to the policing policies configured, and may discard some

low priority packets in case of bandwidth shortage.

If devices of each hop in a network support differentiated service, an end-to-end QoS solution

can be created. QoS configuration is flexible, the complexity or simplicity depends on the

network topology and devices and analysis to incoming/outgoing traffic.

21.1.3 Basic QoS Model

The basic QoS consists of four parts: Classification, Policing, Remark and Scheduling, where

classification, policing and remark are sequential ingress actions, and Queuing and Scheduling

are QoS egress actions.

Basic QoS Model

Classification: Classify traffic according to packet classification information and generate

internal priority and drop precedence based the classification information. For different packet

types and switch configurations, classification is performed differently; the flowchart below

explains this in detail.

Advertising