QTECH QSW-3400 Инструкция по настройке - Manual (Page 45)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
44
6. Configure group
Command Explanation
Global Mode
snmp-server group <group-string>
{noauthnopriv|authnopriv|authpriv} [[read
<read-string>] [write <write-string>] [notify
<notify-string>]] [access {<num-
std>|<name>}] [ipv6-access {<ipv6-num-
std>|<ipv6-name>}]
no snmp-server group <group-string>
{noauthnopriv|authnopriv|authpriv}
[access {<num-std>|<name>}] [ipv6-access
{<ipv6-num-std>|<ipv6-name>}]
Set the group information on the switch. This
command is used to configure VACM for
SNMP v3.
7. Configure view
Command Explanation
Global Mode
snmp-server view <view-string> <oid-
string> {include|exclude}
no snmp-server view <view-string> [<oid-
string>]
Configure view on the switch. This command
is used for SNMP v3.
8. Configuring TRAP
Command Explanation
Global Mode
snmp-server enable traps
no snmp-server enable traps
Enable the switch to send Trap message. This
command is used for SNMP v1/v2/v3.
snmp-server host { <host-ipv4-address> |
<host-ipv6-address> } {v1 | v2c | {v3
{noauthnopriv | authnopriv | authpriv}}}
<user-string>
no snmp-server host { <host-ipv4-
address> | <host-ipv6-address> } {v1 | v2c |
{v3 {noauthnopriv | authnopriv | authpriv}}}
<user-string>
Set the host IPv4/IPv6 address which is used
to receive SNMP Trap information. For SNMP
v1/v2, this command also configures Trap
community string; for SNMP v3, this
command also configures Trap user name
and security level. The
“no” form of this
command cancels this IPv4 or IPv6 address.
snmp-server trap-source {<ipv4-address> | Set the source IPv4 or IPv6 address which is