Micromod MOD: 30MLTraining Manual - Manual (Page 168)

Training Manual
Peer-to-Peer Communications
Figure 10 .19.
IC Block
Connection Menu
• Drag the line from the IC block directly over the middle of the PID block
• Click on the PID block: the Parameter connection list will appear.
• Double-click on RSPI (the remote setpoint input)
Figure 10 .20.
PID Block
Connection Menu
• The connection will now be complete. The connection line will have the source name and
destination name displayed right on it as shown in the figure below. The signal from the other
instrument on the ICN will now be the Remote Setpoint signal for this PID block.
10 - 12