Micromod MOD: 30MLTraining Manual - Manual (Page 97)

Training Manual
PID Loop Lab
Figure 6 .23.
PID Properties
• Change the Setpoint low and high limits to 0 and 200.
• Click on the other tabs at the top (Control, Modes, Options etc, to view different
pages of the PID block.
• We will accept default values for the other parameters. Click on OK to close the
PID block.
14. Configure AOUT block to define the properties of the analog output:
• Configure this block as shown in the next figure:
• The name FCV-100 represents the output to the Flow Control Valve.
6 - 17